Specs for GLOK24 RDA :
- Dimensions: 24.5mm Height (Not Including Drip Tip & 510 Pin )
- 24mm Diameter Wide
- 5mm Deep Juice Well
- Copper Plated 510 Contact Pin
- Innovative Stainless Steel Positive Clamp Center Post & Two Built in Stainless Steel Outer Negative Posts
- Wide Outer Posts Holes 2.7mm Width x 2.5mm Height
- Massive Build Deck
- Dual Coil Cyclopes Airflow
- Adjustable Airflow For Intense Flavor
- PEEK Insulators
- Bottom Feeding Squonker (Sold Separately)
- 1 x GLOK24 RDA by No Limits Mods
- 1 x Bag of Spare O-rings and 3 Flat Head S/S Screws
- 1 x Wide Bore Acrylic Flaked Drip Tip
- 1x Black .5″ Delrin Drip Tip
Rebuildable atomizer: The user of this atomizer must install cotton and wire (coil) in order to use it. This atomizer is not pre-installed with coil. Installation is required. Cotton & Wire sold separately.
Rebuildables are for experienced vapers, not average or beginner vapers with no multimeter or knowledge of how to use a meter, or when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.
This is because:
- A rebuildable coil/cotton MUST be tested carefully with a meter before it is used.
- If it is not tested it is entirely the risk of the user.
- Faulty cotton/coils WILL FAULT electronic devices.
- New coil/cotton units must be tested and then used first on a strong basic electrical APV that has short circuit protection.
- No new coil/cotton assembly should be used on an electronic device until known to be safe.
- These items destroy electronic devices if faulty. This is a known issue.
Due to the nature of this product there is “No Warranty“. This product is for experienced users and requires technical knowledge in order to be properly used.